NEC Univerge SV8100 Features And Specifications Manual page 685

UNIVERGE SV8100
Program
Program Name
Number
10-03-08 ETU Setup (BRIA PKG Setup) –
Dial Sending Mode
10-03-09 ETU Setup (BRIA PKG Setup) –
Dial Information Element
10-03-13 ETU Setup (PRTA PKG Setup) –
Loss of Signal Detection Limit
10-06-01 ISDN BRI Setup – TEI Selection
10-06-02 ISDN BRI Setup – DID Mode
10-06-03 ISDN BRI Setup – SPID 1
10-06-04 ISDN BRI Setup – SPID 2
21-12-01 ISDN Calling Party Number
Setup for Trunks – Calling Party
Number Data
SV8100 Features and Specifications Manual
Description/Comments
ISDN protocol definition. Select
either enblock or overlap sending.
ISDN Protocol definition. If
Overlap Sending is selected in
Program 10-03-08, select either
Keypad Facility (0) or Called Party
Number (1) for the dial information
element.
If the transmit/receive voltage is
less than the setting in Program
10-03-13, the system considers
this as Loss-Of-Signal and the PRI
does not come up. Note that there
are different values based on the
setting in Program 10-03-12 for
the PRI.
Select the method the system
uses when assigning Terminal
Endpoint Identifier (TEI) values to
the BRI Circuit.
Select the method the system
uses when assigning DID Mode to
the BRI Circuit.
Assign the SPID Number for
B-Channel 1.
Assign the SPID Number for
B-Channel 2.
Assign Calling Party Numbers for
each trunk (maximum 16 digits per
entry).
After the above programming
is complete a reset of the
CD-2BRIA is required.
Assigned Data
0 = Enblock Sending
1 = Overlap Sending
(default = 1)
0 = Keypad Facility
1 = Called Party Number
(default = 0)
0 = Level 0
(lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7
(highest sensitivity)
(default = 2)
0 = Select by SPID
number
1 = Select by Channel ID
Number
(default = 0)
0 = Route by Called
Party Number
1 = Route by Redirecting
Number
(default = 0)
Dial up to 20 digits
(default not assigned)
Dial up to 20 digits
(default not assigned)
(maximum 16 digits)
#
1-0, ,
Default:
(All trunks = No setting)
Issue 1.0
Level
1 2 3
2 - 661