Samsung SPE-100 User Manual page 32

network connection and setup
Setting up port range forward for several network encoders
When several network encoder connect to one IP router device, you should forward the
TCP 943 port of the router to the TCP 943 port of a connected network encoder.
If you don't set properly the TCP 943 port of the router, you cannot get any video stream from
J
the web page of the network encoder.
TCP 943 port is a port for the Silverlight policy server of a network encoder.

When Network encoder1 and Network encoder2 are connected to a router :
User
Start End
943 943
3000 3000
3001 3001
4520 4520
4251 4521
8000 8000
8001 8081
You can set a rule of Port Forwarding on the IP router device through its configura-

tion web page.
You cannot change the Silverlight policy server port of a network encoder.

You can change the ports of the network encoder except the policy server port

through its configuration web pages.
2_ network connection and setup

Internet

IP router
Protocol IP Address
TCP 192.168.1.100
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
Network Encoder1
(192.168.1.100)
Web Server Port

VNP Port
RTSP Port
Policy Server Port
Network Encoder2
(192.168.1.101)
Web Server Port

VNP Port
RTSP Port
Policy Server Port
8080
4250
3000
943
8081
4251
3001
943