Samsung SPE-100 User Manual page 28

network connection and setup
3.
In the <Address> pane, provide the
necessary information.
MAC (Ethernet) Address : The MAC

(Ethernet) address of the applicable
network encoder will be set auto-
matically so you don't need to input it
manually.
if using an ip router
IP Address : Enter an address falling in

the IP range provided by the IP router.
ex) 192.168.1.2~254,
192.168.0.2~254,
192.168.XXX.2~254
Subnet Mask : The <Subnet mask> of

the IP router will be the <Subnet mask>
of the network encoder.
Gateway : The <Local ip Address> of

the IP router will be the <Gateway> of the network encoder.
The settings may differ depending on the connected IP router model.
M
For more information, refer to the user manual of the applicable router.
Refer to the "Port Range Forward (Port Mapping) Setup" section of the IP Router's
documentation. (Page 31)
if not using an ip router
For setting <ip Address>, <Subnet mask>, and <Gateway>, contact your network
administrator.
4.
In the <port> pane, provide
necessary information.
HTTP Port : Used to access the

network encoder using the Internet
browser, defaulted to 80. Use the
spin button to change the HTTP Port
value.
VNP Port : Used to control the video

signal transfer, defaulted to 4520.
5.
Enter the password.
This is the login password for the "admin" user who accesses the network encoder.
The default password is "4321".
2_ network connection and setup