Toshiba MJ-1104 Service Manual page 40

[C] Bundle Job Offset Operation
The bundle job offset operation is to sort bundles of paper by placing the first bundle a little forward and
placing the next bundle a little backward, and repeating this set of movement.
The paper transported to the finishing tray is bundled and each bundle is placed by the alignment plates
driven by the front alignment motor (M5) and the rear alignment motor (M6).
The home position of each alignment plate is detected by the front alignment plate home position sen-
sor (S7) and the rear alignment plate home position sensor (S8).
[D] Stapling Operation
The stapling operation is to staple a specified number of paper with the stapler unit.
The stapler unit is moved to the stapling position (the position differs depending on the paper size) by
the stapler unit shift motor (M9).
The home position of the stapler unit is detected by the stapler unit home position sensor (S10).
The stapler interference switch (SW3) detects the no-operation area for the stapling operation and cuts
off the power supply to the stapler while it is switched ON.
The stapling operation is also stopped in the area where while the stapler interference sensor (S11) is
turned ON to prevent the stapler from interfering with other mechanical sections in the equipment.
Stapler unit
home position sensor
MJ-1103/1104
DESCRIPTION OF OPERATIONS
Alignment plate
Front alignment plate
home position sensor
Front alignment motor
Alignment plate
Rear alignment plate
home position sensor
Rear alignment motor
Fig. 3-14
Stapler interference switch
Stapler interference
sensor
Stapler unit shift motor
Fig. 3-15
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
3 - 12