Toshiba MJ-1104 Service Manual page 101

[F] Folding drive unit
(1) Take off the saddle unit.
 P.4-26 "[A] Saddle unit"
(2) Release the harness out of 11 clamps, and
then disconnect each connector of CN11 and
CN14 on the SDL board.
(3) Disconnect the connector of the folding blade
home position sensor. Break binding wire at
4 positions and release the harness from 10
clamps of the folding drive unit.
(4) Remove one clip and then remove the bush-
ing.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-91
Binding wire
Connector
Fig. 4-92
Bushing
Fig. 4-93
4 - 33
Clamp
SDL board
Clamp
Clip
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4