Hitachi XP P9500 User Manual page 153

Perform steps 13 to 17 only if SDS or SVM is being used and you are
¢
migrating a replica of the SDS or SVM state database to the post-
migration environment. In this case, keep the pre-migration
environment recognized by Solaris.
Skip to step 18 if SDS or SVM is being used but you are not migrating
¢
a replica of the SDS or SVM state database to the post-migration
environment.
Skip to step 18 if SDS or SVM is not being used.
¢
13 Check the state database settings.
.
An example is shown below.
14 Add the post-migration boot disk to the SDS or SVM state databse.
.
An example is shown below.
# metadb -a /dev/dsk/c8t50060E80004361D1d1s7
# metadb -a /dev/dsk/c8t50060E80004361D1d2s7
# metadb -a /dev/dsk/c8t50060E80004361D1d3s7
15 Make sure that the post-migration boot disk has been added to the SDS
.
or SVM state database.
An example is shown below.
16 Delete the SDS or SVM state database replica that exists in the pre-
.
migration boot disk.
The following shows an example of executing the command:
# metadb -d /dev/dsk/c0t0d0s7 /dev/dsk/c0t0d1s7 /dev/dsk/c0t0d2s7
17 Make sure that the SDS or SVM state database replica that exists in the
.
pre-migration boot disk has been deleted.
The following shows an example of executing the command:
18 Back up the contents of both the pre-migration and post-migration
.
environments.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-89