Debugging The Ap; Figure 309: Advanced Ap Management; Table 273: Advanced Ap Management - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
you can also manually change the RF channel and power for each radio on an AP. The manual power and channel changes
override the settings configured in the AP profile (including automatic channel selection) and take effect immediately. The
manual channel and power assignments are not retained when the AP is reset or if the profile is reapplied to the AP, such
as when the AP disassociates and reassociates with the switch.
Each AP managed by the Unified Switch is listed by its MAC address and location. The location is based on the value in the
RADIUS or local Valid AP database.
Field
MAC Address
Location
Debug
Radio
Channel
Power

Debugging the AP

You can enable debugging on an AP to allow Telnet access to the access point. Once you Telnet to the AP, you can issue
commands from the CLI to help you troubleshoot.
Document 34CSFP6XXUWS-SWUM100-D7

Figure 309: Advanced AP Management

Table 273 describes the Advanced features you can configure for the AP.

Table 273: Advanced AP Management

Description
Shows the MAC address of the AP.
Shows the AP location, which is based on the value configured in the RADIUS or local Valid
AP database.
To help you troubleshoot, you can enable Telnet access to the AP so that you can debug the
device from the CLI.
The Debug field shows the debug status and can be one of the following:
• Disabled
• Set Requested
• Set in Progress
• Enabled
To change the status, click the Debug status link. The Managed AP Debug page appears.
<Link>Table 274 describes the fields on the new page.
Identifies the radio to which the channel and power settings apply.
Click the Channel link to access the Managed AP Channel/Power Adjust page. From that
page, you can set a new channel for Radio 1 or Radio 2. The available channels depend on
the radio mode and country in which the APs operate. The manual channel change overrides
the channel configured in the AP profile and is not retained when the AP reboots or when the
AP profile is reapplied.Table 275 on page 451
Click the Power link to access the Managed AP Channel/Power Adjust page. From that page,
you can set a new power level for the AP. The manual power change overrides the power
setting configured in the AP profile and is not retained when the AP reboots or when the AP
profile is reapplied. Table 275 on page 451
D-Link Unified Access System
describes the fields on the new page.
describes the fields on the new page.
AP Management Page 449