Configuring Iscsi Optimization (Cli) - Dell PowerEdge M420 Configuration Manual

Configuring iSCSI Optimization (CLI)

This section provides information about the commands you use to configure
iSCSI settings on the PowerConnect M6348, M8024, or M8024-k switch. For
more information about the commands, see the
M6220/M6348/M8024/M8024-k CLI Reference Guide
support.dell.com/manuals.
Command
configure
iscsi enable
iscsi target port
tcp-port-2...tcp-port-16
[
ip-address
[address
targetname
]
448
Configuring iSCSI Optimization
Purpose
Enter Global Configuration mode.
Globally enable iSCSI optimization.
tcp-port-1
Configure an iSCSI target port and, optionally,
] address and name.
] [name
tcp-port-n
•
numbers on which the iSCSI target listens to
requests. Up to 16 TCP ports can be defined in the
system in one command or by using multiple
commands.
ip-address
•
the no form of this command is used, and the tcp
port to be deleted is one bound to a specific IP
address, the address field must be present.
targetname
•
name can be statically configured; however, it can be
obtained from iSNS or from sendTargets response.
The initiator must present both its iSCSI Initiator
Name and the iSCSI Target Name to which it wishes
to connect in the first login request of a new session
or connection.
PowerConnect
at
—TCP port number or list of TCP port
—IP address of the iSCSI target. When
—iSCSI name of the iSCSI target. The