Generator Adjustment (Filament Circuit Learning Program) - Siemens SIREMOBIL Iso-C Troubleshooting Manual

40

Generator adjustment (filament circuit learning program)

NOTE
NOTE
NOTE
Connect the service PC to the serial interface on board D1.
Start the service program.
Select the Diagnostic menu.
Select the Monitoring menu.
In the "Group 1" Combo box, select "Generator adjustment".
Click "Update Start".
WARNING
X
After the "Start fluoro" message in the ACTIONS line, press the radiation release but-
ton on the SIREMOBIL Iso-C hand switch.
Continue to hold the radiation release button as long as the message "Continue fluoro"
is displayed in the ACTIONS line.
"Warmup" appears in the STATUS line, the SIREPHOS is warming up.
After approximately 8 minutes, the message "learning pushfactor" will appear in the
STATUS line.
A maximum of 15 exposures will automatically be released.
The message "Learning done" appears in the STATUS line after the generator adjust-
ment has been successfully completed.
The "Stop monitoring" message appears in the ACTIONS line.
SIREMOBIL Iso-C
The kV offset adjustment must be performed prior to starting
the generator adjustment.
If an error occurs during the generator adjustment, switch
OFF the SIREMOBIL Iso-C and perform the kV offset and gen-
erator adjustments again.
As soon as the generator adjustment is started, press the
radiation release button on the hand switch until the "Stop
monitoring" message appears in the ACTIONS line. If you
deactivate radiation too soon, the generator adjustment must
be completely repeated. Exception: You can briefly stop
pressing the radiation release button (less than 30 seconds)
during the warm-up phase (warm-up displays in the STATUS
line on the service PC) of the SIREPHOS. The generator
adjustment continues when the radiation release button is
pressed again.
X-ray radiation!
See (Safety information / p.
Radiation protection is required. Wear a lead apron.
SPR2-230.840.01.01.02
08.08
Adjustments / Programs
11).
Page 40 of 148
CS PS SP
5.1
© Siemens, 2008
For internal use only