Siemens SIREMOBIL Iso-C Troubleshooting Manual page 115

Replacing boards and components
Monitor zoom
Monitor split
Monitor text
Maximum image number
Disable dose rate selection
in user setup
Unit serial number
Product name
Software backward compati-
ble
Default program changeable Default: Yes. Depending on country-specific regulations
Create external disk
Enable Bridge
Delay 3D-PC/ DICOM Bridge Only available if option "3D Reconstruction" is installed.
Interface to 3D-PC
Default LUT
Default Edge
Default LUT for Subtraction
Subtraction K-Factor, phase
A
Subtraction K-Factor, phase
B
Subtraction Time of phase A Program "4.5". Program a different value only upon cus-
Roadmap K-Factor, phase A Program "32". Program a different value only upon cus-
© Siemens, 2008
For internal use only
Configure No.
Configure Yes.
Configure Yes.
Configure 900.
Set to "No" if equipped with an dose-area product mea-
surement device. The menu "Storage of Dose on disk" and
the menu "Dose on Hardcopy output" are visible in User
Setup. Otherwise set to "Yes".
Program the serial number of the SIREMOBIL. Do not
enter the leading zero.
Program "SIREMOBIL Iso-C".
Configure No.
configure Yes or No.
If the option "3D Reconstruction" or the option "DICOM
Bridge" is installed or a MOD drive is present, configure
Yes. Otherwise configure No.
If the option "3D Reconstruction" or the option "DICOM
Bridge" is installed or a MOD drive is present, configure
Yes. Otherwise configure No.
Configure 120.
Only available if option "3D Reconstruction" is installed.
Configure Yes.
Configure 2. Only program a different LUT curve upon cus-
tomer request.
Configure 1. Program a different edge enhancement curve
upon customer request only.
Configure 1. Only program a different LUT curve upon cus-
tomer request.
Program "32". Program a different value only upon cus-
tomer request.
Program "MD 2". Program a different value only upon cus-
tomer request.
tomer request.
tomer request.
SPR2-230.840.01.01.02
08.08
Page 115 of 148
CS PS SP
115
SIREMOBIL Iso-C