Table of Contents
Advertisement
14
2.4
General safety instructions
• The SFE has no protective measures against contact with other objects and no protective
equipment in the case of defects. Any protective measures must be carried out by the higher-level
machine/system.
• Highly dynamic processes may lead to overloading of the SFE and require corresponding safety
measures.
• Observe the applicable accident prevention and environmental regulations.
• Observe the safety rules and regulations of the country in which the product is used.
• Only use Bosch Rexroth products when they are in a technically perfect condition.
• Observe all notices on the product.
• Persons who mount/install, operate, disassemble or maintain Bosch Rexroth products must not be
under the influence of alcohol, other drugs or medications which might affect their judgment or slow
down their reactions.
• Only use manufacturer-approved accessories and spare parts in order to exclude any hazards to
personnel caused by unsuitable spare parts.
• Comply with the technical data and environmental conditions stated in the product documentation.
• If unsuitable products are installed or used in safety-critical applications, this may lead to
uncontrolled operating statuses in the application which can cause personal injury and/or damage
to property. You should therefore only use product in safety-critical applications if this use has been
expressly specified and permitted in the product documentation.
• You may only commission the product once it has been verified that the end product (for example
a machine or system) into which the Bosch Rexroth products have been installed complies with the
country-specific requirements, safety regulations and standards for the application.
• Except where otherwise documented, Bosch Rexroth products are intended for operation in
networks which have been locally, physically and logically secured, with access restricted to
authorized persons and not classified in accordance with IEC 62443-4-2.
• Only firmware or a GUI (SFE tool) provided by Bosch Rexroth may be used. This is provided by the
Bosch Rexroth service team or via the Bosch Rexroth website.
2.5
EMC standards
EMC standards have been tested and positively confirmed in accordance with the following standards.
Emitted interference according to
EN 61000-6-4
Passed
Interference immunity according to
EN 61000-6-2
Passed
en
2
Safety
Advertisement
Table of Contents
