Table of Contents
Advertisement
NOTE: in cases where only one battery housing is installed within the UPS
cabinet, the longer of two battery cable looms can be removed and retained as
a maintenance spare.
9.7 Mounting and connecting the DC Housing Module
Step No.
6
The DC housing provides a termination point for all batteries fitted within a Battery
Expansion Cabinet.
1. Pass the DC Housing module through the front door aperture of the cabinet outer
case and place on top of the previously installed Battery Housing module.
2. Using the side stops, slide the DC Housing module into place, aligning the holes
in the bottom flange with the threaded holes in the top of the Battery Housing
module below. Secure into place using the bolts provided.
3. Secure the loose earth cable to the marked earth stud on the side of the Battery
Housing module below.
NOTE: The DC Housing module is sometimes fitted to a Battery Housing
Module before shipping. If this is the case, check that the DC housing is secure
and that the earth cable is properly connected, then follow the normal Battery
Housing module installation steps (section 9.5) ensuring the DC Housing
module is placed at the top of the stack.
Version
7
Last Editor
Ore Oluwatudimu
Document
UPS Solution General Handbook
Name
Copyright ã Siemens plc 2017 All Rights Reserved
Figure 9-8: Battery Cable Loom Connectors
UPS Cabinet
N/A
Page 35 of 76
TS008468
Infrastructure and Mobility, Traffic Solutions
Battery Expansion Cabinet
Mount and connect the DC
Housing module
Status
ISSUED
Date
31/01/2017
Doc. No.
667/HB/47750/000
Sopers Lane, Poole, Dorset
BH17 7ER
Refer to
Section 9.7
Advertisement
Table of Contents
