Siemens 667/HB/47750/000 General Handbook page 33

Fitting further Battery Housing Modules:
1. Pass the Battery Housing module through the front door aperture in the cabinet
outer case and place on top of the previously installed battery housing.
2. Using the back and side stops slide the Battery Housing into place, aligning the
countersunk holes on the bottom surface with the threaded holes in the top of the
Battery Housing module below. Secure using the fixings provided.
3. Pass the loose earth wire from the right side of the Battery Housing through the
opening in the housing bottom and secure to the marked earth stud on the
Battery Housing module below.
Figure 9-6: Earth Connection between Battery Housing modules
Version 7
Last Editor Ore Oluwatudimu
Document UPS Solution General Handbook
Name
Copyright ã Siemens plc 2017 All Rights Reserved
Figure 9-5: Battery Housing module mount
Page 33 of 76
TS008468
Infrastructure and Mobility, Traffic Solutions
Sopers Lane, Poole, Dorset
Status ISSUED
Date 31/01/2017
Doc. No. 667/HB/47750/000
BH17 7ER