Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 460

Configuring Redundant Site Controller
Process 15-3 How to Configure Redundant Site Controllers
1
2
3
4
Procedure 15-6 Site Controller Hardware Pre-Checks
1
2
3
4
Procedure 15-7 Site Controller Configuration Files
1
2
3
4
5
15-30
Perform Site Controller Hardware Pre-Checks, as described in
Hardware Pre-Checks," on page
Configure the Site Controller Configuration Files, see
Configuration Files," on page
Configure Ethernet ports connecting the two Site Controllers, as described in
"Configure Ethernet Ports," on page
Configure the ID values of the Site Controllers, see
IDs," on page 15-32.
Ensure that both Site Controllers are correctly installed and are running identical software
applications, Boot images and configuration files.
In order for the Redundant Site Controller feature to work correctly, the Site Controller and
BR Boot1 version must be:
• TSC_RLJ_BOOT1–R06.40.07 or later for SC.
• BRC_RLJ_BOOT1–R06.40.05 or later for Base Radio.
The Boot1 version can be checked on the Site Controller and BRs by resetting the
Site Controller/BR and interrupting the startup sequence when prompted to go into
Boot1 mode. The software version is displayed when entering Boot1 mode.
Check that the redundant Site Controller Ethernet Link cables are connected correctly, as shown
in Figure 15-11.
Proceed to Procedure 15-7
In order to check that the Site Controller configuration files have the Standby Site
Controller Installed parameter enabled, follow the steps below.
Log onto the Site Controller Application MMI.
From the SC: prompt, run the command display config.
Check the output of the configuration and confirm if the Standby Site Controller parameter is
enabled or not.
If no Standby Site Controller is enabled, upload the Active Site Controller configuration file.
Modify the configuration file in TESS to enable Standby Site Controller.
15-30.
15-30.
15-31.
Procedure 15-9, "Configure Site Controller
below.
Chapter 15: Expansion Options
Procedure 15-6, "Site Controller
Procedure 15-7, "Site Controller
Procedure 15-8,
6802800U74-N September 2009