Support Bearing Replacement - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

SUPPORT BEARING REPLACEMENT

1. Remove the rear prop shaft from the vehicle (see

Chapter 7 – Rear Prop Shaft Removal, page 7.28).

2. Using a rubber mallet, remove the rubber isolated

bearing support from the shaft to expose the bearing.

3. Using a commercially available 2-jaw puller, remove

the bearing from the end of the prop shaft.

4. Clean the bearing mounting surface on the shaft and

apply Loctite

clean surface.

5. Install the new support bearing assembly onto the

end of the prop shaft.

retaining compound to the

6. Using an appropriate bearing/bushing installation

sleeve, drive the support bearing assembly onto the

prop shaft until it seats against the shoulder on the

Only drive on the inner race of the bearing. Driving on

the bearing in any other location will damage the

7. Wipe the bearing and shaft clean of any excess

retaining compound.

Do not allow any Loctite

8. Install the rear prop shaft into the vehicle (see

Chapter 7 – Rear Prop Shaft Installation, page 7.29).

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

to get in the bearing.

Table of Contents