Table of Contents
Advertisement
10 / 52
Intended use of E-STOP control units
4
Intended use
4.1
General information on the intended use
The Bosch Rexroth operator displays are passive operator and visualization terminals. They form a
PC-based operator terminal when used with a Bosch Rexroth control cabinet PC.
NOTICE
Typical areas of application of the operator display:
•
Handling and assembly systems
•
Packaging and food processing machines
•
Printing and paper converting machines
•
Machine tools
•
Wood processing machines
The operator displays may only be operated under the mounting and installation conditions, the
position and the ambient conditions (temperature, degree of protection, humidity, EMC etc.) specified
in this documentation.
4.2
Intended use of E-STOP control units
E-STOP control units are electromechanical switching devices to protect persons. E-STOP control units
are used for a fast switch-off, to reach a safe state for machines, vehicles and systems and to avoid or
reduce hazards and damages to people and machines.
The following regulations apply in particular to commissioning, use and technical inspections:
•
Machinery directive 2006/42/EC
•
Safety regulations
•
Accident prevention regulations/safety rules
Manufacturers and operators of machines with an E-STOP control unit are responsible to comply with
the operating manual and the current safety guidelines and rules.
To install and operate E-STOP control units, asses the risk for an intended use. Note the following
requirements:
Bosch Rexroth AG
Risk of damaging the device if not expressly stated accessories, mounting
parts and other components, cables, lines, software and firmware are used.
The operator displays may only be used as intended and with the accesso-
ries, mounting parts and other components specified in this documentation.
Components that are not expressly mentioned must neither be attached nor
connected. The same applies to cables and lines.
Only to be operated with the component configurations and combinations
expressly defined and with the software and firmware specified in the corre-
sponding functional description.
ctrlX HMI DE0015, DE0021
R911405731, Edition 03
Advertisement
Table of Contents
