Http Connection To Id 40/Slk; Troubleshooting The Id 40/Slk Network Connection - Bosch Rexroth ID 40 Manual

132/176 Web interface
Bosch Rexroth AG, MIT: ID 40, 3 842 530 344/2014-05
PROOF COPy 1 | 20.05.2014 | FOR INTERNAL USE ONLy

10.4 HTTP connection to ID 40/SLK

Once the "ID 40" connection is set up and established on the computer (see
Chapter 10.3 "Setting up the network connection to the ID 40/SLK"), the SLK can
be operated using the web browser on the computer or automated using application
programs (see Chapter 10.7 "Web access from application programs").
As with a website, enter the web address (URL) of the SLK in the address bar of your
browser, press ENTER, and after a brief loading period, the homepage of the ID 40/SLK
will appear.
The network address or IP address is part of the web address. The default IP
address of the SLK is 192.168.66.1. Chapter 10.3.5.3 "Changing the ID 40/SLK
network address" describes how this address can be changed if necessary.
The web address should be as follows:
http://192.168.66.1/index.html
The ID 40/SLK homepage loads within around 10 seconds.
If the page does not appear, refer to Chapter 10.4.1 "Troubleshooting the ID 40/SLK
network connection" below.
The ID 40 website is described in Chapter 10.5 "The ID 40/SLK website".
10.4.1

Troubleshooting the ID 40/SLK network connection

If your computer is connected to a local network (LAN, Intranet) or there are other
network connections (e.g., DSL, modem), it may not be possible to access the ID
40 website or, if the SLK connection is active, the network resources due to your
computer's network settings.
The following chapters recommend steps that should allow simultaneous access to
the ID 40 website and any LAN.
If you are not familiar with network configurations, consult your network
administrator. Do not make any ill-advised changes to the network settings.
10.4.1.1 Deactivating the default gateway
If your computer needs to access the Internet, an intranet, a file server, etc. in
addition to the ID 40/SLK connection, the default gateway cannot be changed to the
ID 40/SLK connection. Otherwise you will no longer be able to access your network
resources once the connection to the SLK is established.
Deactivating the default gateway is described in Chapter 10.3.2 "Setting up a
network connection" under the phrase Use default gateway on remote network.
Terminate the connection (if active) and re-establish to apply the settings.