Safety Instructions; New In The 4.X Versions Of The Id 40/Slk Software - Bosch Rexroth ID 40 Manual

Intended use
Safety precautions for
normal operation
Instructions for operators
Liability and warranty

1.4 Safety instructions

The MDT mobile data tag and SLK read/write head together form the ID 40
identification system and may only be used for this purpose in an industrial setting in
accordance with Class A of the EMC Act. The manufacturer's declaration documents
the ID 40 identification system's compliance with the requirements of the relevant
standards. Country-specific features and regulations have to be additionally taken
into account, if applicable.
Only specially trained personnel may install and operate the system. The relevant
safety instructions must be observed. In particular, measures must be taken to
prevent danger to personnel and equipment in the case of a defect in the
identification system. This includes maintaining the permissible ambient conditions
and the use of an approved power supply. Details on this can be found in the
Technical data chapter.
The function of the identification system and all connected components must be
checked at regular intervals. If there are any indications that the identification
system is not working properly, it must be taken out of operation and secured
against unauthorized use.
Operating personnel should receive training from supervisors that includes safety
precautions and operating the ID 40 in accordance with this manual.
The manufacturer does not accept any liability or warranty claims for damages
arising from improper use or intervention that is unauthorized or not described in
this manual.

1.5 New in the 4.x versions of the ID 40/SLK software

• TCP/IP connection via RS232 interface for supporting web-based system and MDT
diagnostics, see Chapter 10 "Web interface".
• Access to MDT and SLK data via web browser, also in Chapter 10 "Web interface".
• Access to MDT and SLK data via user application program using the web interface,
see Chapter 10.7 "Web access from application programs".
• The commands for opening and closing transfer are no longer needed, since the
presence of the MDT is now monitored. It is no longer possible to switch the MDT
unnoticed, see Chapter 6.9 "MDT lifeguarding".
About this manual
3 842 530 344/2014-05, MIT: ID 40, Bosch Rexroth AG
PROOF COPy 1 | 20.05.2014 | FOR INTERNAL USE ONLy
11/176