Supplementary Software Conditions; Start Program - Siemens SINUMERIK 840D sl Function Manual

Operation via PG/PC (B4)
3.2 Software installation
3.2.3

Supplementary software conditions

● Function keys
● Monochrome screen
● User-friendly parameterization
3.2.4

Start program

Program call
The MMC 102/103 software is started on a PG/PC either
● from the program manager through selection of the "SINUMERIK 840D MMC V2.3"
Figure 3-8
● from the file manager by a double click on file REG_CMD.EXE.
Communication
If no communication link can be set up to the NCK or 611D, then the message "No
communication to NCK" is displayed. If communication is interrupted, e.g. by an NCK reset,
then the MMC 102/103 software tries to re-establish the communication link itself.
268
The function keys must not be actuated in any of the displays until the display has fully
built up.
When a monochrome screen is used, the colors used by the MMC must be adapted
accordingly. For this purpose, select the color scheme "Monochrome" or "Mono positive"
in display "Commissioning\MMC\Color setting".
The display "Commissioning\MMC\OPI parameters" can now be called up even if there is
no link to the NC kernel. This means that the OPI parameters for baud rate and network
address can be set easily.
program group followed by a double click on the "MMC Startup" symbol or
SINUMERIK 840D MMC program group
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions