Addendum - GE eBike III basic Series Service Manual

a
ddenduM
e s
rrorCodes oftware e
Every electronic module of the eBike III ergometers has its own error codes.
If an error occurs, a hexadecimal code is displayed on the ergometer display and internally stored with date/time of first
occurence and numbers of recurrences.
The displayed hexadecimal code is a combination of single error bits, each representing a special fault condition.
example: Displayed Error
Bit conversion:
Error bits set:
• A service software to download Error codes and device settings from the eBike III
is available (downloadable) from Infocenter / section software download / eBike
III service tool
e dtu (C
rror Code BIts ontrol terMInal
Bit Error
0 Illegal program jump
1 Wrong SW configuration
2 not used
3 LCD communication error
4 +24V out of range
5 not used
6 not used
7 Safety state mode
8 not used
- 94 -
B III
Ike
Source: DTU
Err.Code: 0018 (hexadecimal)
0 0 0 0
Bit 3 LCD communication error
Bit 4 +24V out of range
Note
pCB)
Reaction
Safety shut down
Safety shut down
Safety shut down
eBike III basic / comfort
0 0 0 0 0 0 0 1
Display / Info Troubleshooting
- restart eBike (OFF / ON)
- if error persists:
Warning - perform software update
- check LCD connection
- if error persists:
Internal error - check power supply
- check connections:
- restart eBike (OFF / ON)
- if error persists:
1 0 0 0
(0018 hex)
replace control terminal
replace control terminal
power supply to switch to LIU
cable DTU <-> LIU
replace control terminal
2018111-336 Rev. B