Configuring Help Displays - Siemens SINUMERIK 840D Programming Manual

1
General
1.4 Cycle support in program editor (SW 4.3 and higher)

1.4.4 Configuring help displays

Explanation
Help displays for MMC 100/MMC 100.2
If you wish to modify the standard graphics or create
additional graphics, you will need to have a graphic
program on your PC. The size of the graphic is
limited to max. 272 ⋅ 280 pixels. It is recommended
that you make all graphics the same size.
The MMC uses the PCX format of Zsoft Paintbrush
as graphic format. If you do not have a graphic
program that can create this format, you can use the
Paint Shop Pro program to convert your graphics.
The names of the bitmaps are directly related to file
uc.com. If a file is configured there, for example with
//C60 (POSITION1), the bitmap must be called
C60.bmp for MMC 100.2 or C60p.bmp for MMC 103.
The Paint Shop Pro application is not included
on the diskette supplied by Siemens.
Help displays for MMC 102/103
The help displays of the MMC 102/103 are located in
the file system under the directory H\DP.DIR\HLP.DIR.
You can use the "Copy" function in the Services
menu to read data from a floppy disk. To do this,
select the destination directory via "Interactive
programming" and "DP Help".
1-34
G0
Example of cycle parameterization graphics
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
11.02
G1
RTP
RFP+SDIS
RFP
DP=RFP-DPR
© Siemens AG, 2002. All rights reserved