Siemens SINUMERIK 840D sl Commissioning Manual page 504

Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
[MISC]
IconPath
Relative path to the directory in which the icons are stored.
The path is relative to ..\mmc2. The same directory can also be present in Add_on,
oem, and user. The icons are also searched for in these directories.
Default:
EndIcon
Icon for the last block. This icon must be located in the directory that was specified in
IconPath.
GCodeIcon
Icon for free DINCode. This icon must be located in the directory that was specified in
IconPath.
ShowBlockNumber
Display of line number (e.g., N210). The number of the first line of a block is always
displayed.
0: Line number is not displayed
1: Line number is displayed
TimeFormat
The displayed lines can be formatted in VB syntax, e.g., number of decimal places.
####0.000: Time display with 3 decimal places.
CopySyncBuffers
For the synchronized view, you can specify here whether or not the empty blocks that
were inserted for synchronization will be copied.
0: Do not copy empty blocks
1: Copy empty blocks
[INSERT]
TemplateForNewBlock
Shortcut CTRL+I can be used during Editing mode of a step to insert a SEFORM
instruction. The text to be inserted can be configured here.
[Cache]
Enabled
A file can be opened faster by using the cache.
The individual data for the sequence view are stored separately and can be back-
accessed, provided the part program has not been changed.
Presently, only the following setting is available
0: Cache is not active.
[DefaultIcons]
These icons are displayed if icons are not specified in the individual definitions, e.g., if an
icon is not included in SEFORM(...). This icons must be located in the directory that was
specified in IconPath.
Block
Icon for main sequence SEFORM(..., 0, ...)
IM4/2-110
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IconPath = ae\skpicto
© Siemens AG, 2005. All rights reserved
08/2005