Preset Actual Value Memory, Preset, Scratching - Siemens SINUMERIK 840D sl Commissioning Manual

Starting Up HMI Embedded (IM2)
4 Functions/Parameterization
Set the general machine data
MD 18600: MM_FRAME_FINE_TRANS = 0, the fine offset cannot be entered or
programmed.
References:
4.11.3

Preset actual value memory, preset, scratching

Introduction
The behavior of the scratching and preset actual value memory, PRESET
functions is influenced by a number of machine data. The selected settings also
affect operation. (Display of softkeys and values, saving of input values.)
References:
With the introduction of system frames in software version 6, two variants are
available for the functions. The variants are differentiated using a channel-specific
machine data MD 28082: MM_SYSTEM_FRAME_MASK:
Bit:
Variant 1 without system frame:
The MD does not exist (older NCK software versions) or bit 0 for system frame for
scratching and preset is not set.
Variant 2 with system frame:
Bit 0 for system frame for scratching and preset is not set in the MD.
Display machine data MD 9422: MA_PRESET_MODE defines the PRESET/base
offset in the JOG mode.
0: No softkey
1: The old PRESET in the Machine operating area (default).
2: Preset actual value memory:
3: Preset actual value memory: NCK with/without system frame: Setting
possible in the currently active frame.
IM2/4-52
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
/FB1/K2: Axes, Coordinate Systems, Frames,...External Work
Offset.
/BEM/HMI Embedded Operator's Guide
0 Preset, scratching
1 External work offset
2 TCARR, PAROT
3 TOROT, TOFRAME
4 Workpiece reference points
5 Cycles
6 Frame transformation
NCK without system frame: Setting only possible with active G500 in the
base offset, otherwise error message.
NCK with system frame: Setting in the system frame possible.
The basic frame is not used with G500 in the system frame.
© Siemens AG, 2005. All rights reserved
08/2005