Siemens SINUMERIK 840D sl Operation/Programming Manual page 221

08/2005
5
Dialog selection:
Changing
Change
selection
Select
dialog
Accept
dialog
Contour element: Insert
...
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Enter the desired changes.
Press the "Accept" softkey.
The current values for the contour element are accepted and the
change is immediately visible in the programming graphics.
If when you entered the data for a contour element there were two
different contour options and you chose the wrong one, you can alter
your choice afterwards. If the contour is unique as a result of other
parameters, the system will not prompt you to make a selection.
Open the input screen form for the contour element.
Press the "Change selection" softkey.
The two selection options appear again.
Press the "Select dialog" softkey to switch between the two
different contour options.
Press the "Accept dialog" softkey.
The chosen alternative is accepted.
Select the contour in the machining plan.
Press the "Cursor Right" key.
The individual contour elements are listed.
Place the cursor on the contour element after which the new
element is to be inserted.
Select a new contour element via softkey.
Enter the parameters in the input screen.
Press the "Accept" softkey.
The contour element is inserted in the contour. Subsequent contour
elements are updated automatically according to the new contour
status.
ShopTurn Functions
5.4 Contour turning
5
5-221