HP MSR2000 Configuration Manual page 373

Figure 87 Network diagram
Table 32 Interface and IP assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configuring basic IPv6 MPLS L3VPN:
Configure OSPF on the MPLS backbone to allow the PEs and P device to learn the routes of the
loopback interfaces from each other.
Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs.
Establish an MP-IBGP peer relationship between the PEs to advertise VPN IPv6 routes.
Configure the VPN instance of VPN 1 on PE 1 to allow CE 1 to access the network.
Configure the VPN instance of VPN 1 on PE 2 to allow CE 2 to access the network.
Configure BGP as the PE-CE routing protocol, and redistribute routes of the CEs into the PEs.
For more information about basic IPv6 MPLS L3VPN configurations, see
L3VPNs."
# Execute the display ipv6 routing-table command on CE 2 to verify that CE 2 has not learned the
route to the VPN (100::/96) behind CE 1.
<CE2> display ipv6 routing-table
Destinations : 6 Routes : 6
Interface IP address
GE2/1/1 10:1::2/96
GE2/1/2 100::1/96
Loop0 10.1.1.1/32
GE2/1/1 10:1::1/96
GE2/1/2 20.1.1.1/24
GE2/1/1 10:2::2/96
GE2/1/2 200::1/96
Device Interface
P Loop0
GE2/1/1
GE2/1/2
PE 2 Loop0
GE2/1/1
GE2/1/2
364
IP address
2.2.2.9/32
20.1.1.2/24
30.1.1.1/24
10.1.1.2/32
10:2::1/96
30.1.1.2/24
"Configuring IPv6 MPLS