Siemens SINUMERIK 810DE powerline Equipment Manual page 92

6 I/O Modules
6.1 Single I/O module
This results in the following address space:
1. Input range
2. Output range
Only one I/O module is possible per chain.
The address range is assigned automatically during startup. Parameterization is
not required.
In HW Config, it is possible to treat the 810D I/Os as the equivalent arrange-
ment of S7-300 modules.
Fig. 6-3
6-90
X3 IN
X404
X405
X406
Input byte (chain number *32) to (chain number *32) +7, i.e. from input byte
32 to input byte 39 for operation in chain 1
Output byte (chain number *32) +8 to (chain number *32) +11, i.e. from out-
put byte 40 to output byte 44 for operation in chain 1
X111
P-bus
SINUMERIK 810D
with
integrated PLC
SINUMERIK 810D with 3 I/O chains (max. configuration)
SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition
X3 OUT
32 inputs 0 to 31
32 inputs 32 to 63
32 outputs 0 to 31
Chain 1
Chain 2
Single I/O
module
Single I/O
module
Single I/O
module
Copyright © Siemens AG 2006
Chain 3
J