Siemens SINUMERIK 810DE powerline Equipment Manual page 104

8 DMP Compact Modules
8.3 DMP compact module 8O (6FC5111-0CA03-0AA2)
Table 8-4
Number of outputs
Galvanic isolation
Power supply V
Signal level of the outputs (typically)
Output load for signal "1" (rated value)
Short-circuit protection
Power loss at 30 V
Operating frequency for
Total load capability at 55
current of all outputs)
Delay time
Delay time
Length for cables
Weight
Important
!
As of product version B, a new output driver is used for the DMP compact
module 8O. It behaves as follows:
In the event of a fault triggered by overcurrent or short-circuit, the outputs
automatically reconnect after the fault has been rectified.
4 outputs each are powered by a power supply. For each group of 4 outputs
(outputs 0 to 3 and 4 to 7), the total of the output currents must not be greater
than 4 A. (This corresponds to a coincidence factor of 50 % if each output is
under full load). All 8 outputs can be loaded simultaneously with 1 A for
example.
Important
!
If inductive loads are used, switching voltage peaks must be limited by external
free-wheeling diodes or RC connections.
8-102
Technical data of DMP compact module 8O
LOAD
– Rated value
– Perm. range
– Ripple
– For signal "0"
– For signal "1"
– Ohmic load
– Lamp load
– Inductive load
– Ohmic load
– Lamps
– Inductive load (for rated
current, higher values are
permissible for lower cur-
rents)

C (relative to the total rated
for tp
LH
for tp
HL
SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition
8 digital outputs
Yes
24 V DC
20.4 V to 28.8 V
3.6 Vpp
Open
V –80 mV
load
2000 mA
25 W
2000 mA
Yes
Max. 3.1 W
100 Hz
11 Hz
2 Hz
50 %
tp = max. 0.5 ms
LH
tp = max. 0.5 ms
HL
max. 50 m
about 145 g
Copyright © Siemens AG 2006