Multi-Channel Step Sequence Programming (Option) - Siemens SINUMERIK 840Di sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840Di sl:
- Commissioning manual (632 pages) ,
- Programming manual (560 pages) ,
- Function manual (274 pages)
Table of Contents
Advertisement
6
01/2008
6.5
Multi-channel step sequence programming (option)
Application
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
6.5
Multi-channel step sequence programming (option)
Function
Multi-channel step sequence programming is an extension of the
single step sequence display to several channels.
Support is provided with the following tasks when working with multi-
channel workpiece programs:
•
Open by pressing the "Edit workpiece" softkey" once: All
programs, which should be selected and executed in several
channels simultaneously, are loaded into the editor.
•
Display the step sequences of several programs: Left icon
column per channel; right step display of the selected channel.
You can switch between two display modes:
− Standardized and synchronized view during program
generation before executing a trial run
− Time-proportional and synchronized view after executing a
trial run on the basis of times recorded per step.
•
Navigate in the channel's program (cursor up/down as well as
previous/next step of same type) and from program to program of
neighboring channels (cursor right/left)
•
Edit the program in the standard ASCII environment (recompile
or input softkey) or using the block functions at step level (change
sequences in the program or distribute across programs).
•
Optimize the sequence, processing time: Including the "Record
times" program control, traverse programs.
The program sequence is monitored using "traces", which record the
times for each step in the DAT file and form the basis for the time
view. Based on this time-proportional view, programmers can quickly
recognize which steps require a long time and carry out a
redistribution or change in the sequence in relation to the channels.
Note
The preconditions for support when opening multi-channel workpiece
programs can be configured by the machine manufacturer or machine
setter: See "Create programming support for multi-channels".
"Program" operating area
6-267
6
Advertisement
Table of Contents
