Network Controller - Bosch Praesideo 3.5 Installation And User Instructions Manual

Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration
The hexadecimal serial number of a unit consists of 8
digits ranging from 0 to F. The combination of the first
and second digit identifies the type of unit.
table 42. 1 : Serial number ranges (addressable units)
Type no. Description
PRS-NCO-B

Network Controller

PRS-16MCI Multi Channel Interface
LBB4402/00 Audio Expander
LBB4404/00 CobraNet Interface
PRS-NSP Network Splitter
PRS-FIN(S) Fiber Interface
PRS-FINNA
PRS-1P500 Power Amp. 1 x 500 W
PRS-2P250 Power Amp. 2 x 250 W
PRS-4P125 Power Amp. 4 x 125 W
LBB4428/00 Power Amp. 8 x 60 W
LBB4430/00 Call Station Basic
LBB4433/00 Call Station Kit
PRS-CSI Remote Call Station
(Call Station Interface)
PRS-CRF Call Stacker
Note
If the real serial number is not (yet) known, the
temporary serial number 0 can be used for all
units. In this way, most of the configuration can
be done off-line already. Communication with
actual units in the system is only possible when
the temporary serial numbers have been
replaced by the real serial numbers. Units in the
configuration with the serial number 0 are
ignored by the actual system in operation.
Bosch Security Systems | 2011-02
42.3 Network controller
Proceed as follows to register the network controller:
1 Go to Configure > System definition > Network controller.
A screen similar to the one in figure 42.3 appears in
the main frame of the web interface.
ID
11
1B
12
1C
14
15
0B
0A
figure 42.3: Register network controller, step 1
09
08
2 Enter a name for the network controller in the Name
0C
field.
0E
1D
Note
1F
The name is also shown on the display of the
network controller.
3 Enter the hexadecimal serial number of the network
controller in the Serial number field.
4 When the network controller is physically present, it
can be enabled by ticking the Enabled checkbox.
Note
The serial number itself is not checked.
However, the software checks that all entered
characters are hexadecimal characters and that
the serial number is 8 characters long or is 0.
5 Submit the changes. Note that the changes are not
permanent until the configuration is saved. (see
section 40.4.4 and section 40.4.5).
en | 332