Siemens MICROMASTER 440 Operating Instructions Manual page 90

3 Functions
Fixed frequency 1
P1001 = 0
Defines the fixed frequency setpoint 1 (FF1) in Hz.
Fixed frequency 2
P1002 = 5
Fixed frequency 3
P1003=10
Fixed frequency 4
P1004=15
Fixed frequency 5
P1005=20
Fixed frequency 6
P1006=25
Fixed frequency 7
P1007=30
Fixed frequency 8
P1008=35
Fixed frequency 9
P1009=40
Fixed frequency 10
P1010=45
Fixed frequency 11
P1011=50
Fixed frequency 12
P1012=55
Fixed frequency 13
P1013=60
Fixed frequency 14
P1014=65
Fixed frequency 15
P1015=70
Fixed frequency mode - Bit 0
P1016 = 1
Defines the selection method for
fixed frequencies.
Fixed frequency mode - Bit 1
P1017 = 1
Fixed frequency mode - Bit 2
P1018 = 1
Fixed frequency mode - Bit 3
P1019 = 1
Fixed frequency mode - Bit 4
P1025 = 1
Fixed frequency mode - Bit 5
P1027 = 1
90
When defining the function of the
digital inputs (P0701 to P0708),
three different types can be selected
for fixed frequencies:
15 = Direct selection
(binary-coded)
In this particular mode, the
appropriate digital input always
selects the associated fixed
frequency,
e.g.:
Digital input 4 = selects fixed
frequency 4.
If several inputs are simultaneously
active, then these are summed. An
ON command is additionally
required.
16 = Direct selection +
ON command
(binary-coded + On / Off1 )
In this mode, the fixed frequencies
are selected as for 15, however
these are combined with an ON
command.
17 = BCD selection +
ON command
(BCD-coded + On/ Off1 )
The BCD-coded operating mode is
effective for digital inputs 1 to 4.
1 Fixed freq., binary-coded
2 Fixed freq., binary-coded +
ON command
3 Fixed freq., BCD-coded +
ON command
NOTE
For settings 2 and 3, all parameters
P1016 to P1019 must be set to the
selected value so that the drive
inverter accepts the ON command.
1 Fixed freq., binary-coded
2 Fixed freq., binary-coded +
ON command
MICROMASTER 440
Issue 10/03
Operating Instructions
6SE6400-5AW00-0BP0