Toshiba e-STUDIO163 Service Manual page 147

[Q] Feed gear unit
(1) Take off the main motor drive unit.
P.9-7 "[C] Main motor drive unit"
(2) Take off the registration roller clutch.
P.10-18 "[L] Registration roller clutch
(CLT1)"
(3) Disconnect 1 connector, remove 2 screws,
and then take off the feed gear unit.
Note:
Set the gear-A in the installation position of
the equipment before installing the feed gear
unit.
(4) Remove 1 screw and take off the pickup
solenoid from the feed gear unit.
December 2005 © TOSHIBA TEC
Feed gear unit
Fig. 10-43
Pickup solenoid
Fig. 10-44
e-STUDIO163/203 PAPER FEEDING SYSTEM
10 - 21
Connector Gear-A
Feed gear unit
10