Suzuki GRAND VITARA XL-7 Owner's Manual page 615

10B-38 AIR BAG SYSTEM
[A] Fig. for STEP 1/[B] Fig. for STEP 2/[C] Fig. for STEP 3
Special tool
(A) : 09932-75020
NOTE:
Upon completion of inspection and repair work, perform following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to DTC CLEARANCE), if any.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
DTC B1036 and B1038 :
Step
1 1) Ignition switch OFF.
2) Disconnect driver air bag (inflator) module
connector, passenger air bag (inflator) mod-
ule connector, driver pretensioner module
connector, and passenger pretensioner
module connector.
3) Disconnect forward sensor.
4) Check proper connection to forward sensor
connector at "ORN/GRN" and "ORN/BLU"
terminals or "YEL/GRN" and "YEL/BLU" ter-
minals.
5) If OK then measure resistance between ter-
minals of forward sensor.
Is resistance 738 - 905 Ω?
2 1) Disconnect SDM connector.
2) Check proper connection to SDM connector
at terminals "Q01-13" and "Q01-14" or ter-
minals "Q01-18" and "Q01-19".
3) If OK then measure resistance between ter-
minal "Q01-13" and "Q01-14" or terminal
"Q01-18" and "Q01-19".
Is circuit open?
Action Yes
Go to step 2.
Go to step 3.
No
Replace forward sensor.
Repair short from "ORN/
GRN" wire circuit
(between forward sensor
and SDM) to "ORN/BLU"
wire circuit (between for-
ward sensor and SDM), or
from "YEL/GRN" wire cir-
cuit (between forward
sensor and SDM) to "YEL/
BLU" wire circuit
(between forward sensor
and SDM).