5E2-20 ANTILOCK BRAKE SYSTEM (ABS)
DTC C1015 (DTC 15) – G Sensor Circuit and 4WD Lamp Circuit
1. Ignition switch
2. G sensor
DESCRIPTION
G sensor
While a vehicle is at stop or running, if the potential difference between the sensor signal terminal "E136-11" and
the sensor ground terminal "E136-13" is not within the specified voltage value, or if the signal voltage while at a
stop does not vary from that while running, this DTC is set.
Therefore, this DTC may be set when a vehicle is lifted up and its wheel(s) is turned. In such case, clear the
DTC and check again.
When G sensor is installed to 2WD vehicle, this DTC is set.
4WD lamp
When 4WD lamp circuit open or shorted, this DTC is set.
3. ABS hydraulic unit/control module assembly
4. ABS hydraulic unit/control module connector
5. 4WD lamp
7. 4WD switch
6. ECM (PCM)