Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-response
-iscsi-disc-rsp
-tpgs
-tpg-referrals
-iscsi-rsv-range
■
Example(s)
The following example sets up the host response for host response #1. The new host response name is "win-
x". The response status is Busy status. The host command timeout is 30 seconds:
CLI> set host-response -host-response-number 1 -name win-x -status busy -timeout 30
Optional. This parameter specifies the reply mode for the iSCSI Discovery request.
port
Replies to the server with only the information for the specified iSCSI ports (iSCSI
names and IP addresses).
all
Replies to the server with the information for all the iSCSI ports (iSCSI names and
IP addresses).
Optional. This parameter specifies whether to enable Target Port Group Support (TPGS) for
Inquiry Standard Data Version 5.
enable
TPGS is enabled (default).
disable
TPGS is disabled.
Optional. This parameter specifies whether to enable the TPG Referrals. When "enable" is set
for this parameter, TPG Referrals are only performed when TPGS is enabled and Asymmetric/
Symmetric Logical Unit Access is set to ACTIVE/ACTIVE-PRFERRED_PATH.
Set "enable" for this parameter only for connection environments in which the ETERNUS Mul-
tipath Driver that is being used supports TPG Referrals.
enable
TPG Referrals is enabled.
disable
TPG Referrals is disabled (default).
Optional. This parameter specifies the reservation management range for iSCSI connections.
port
Each CA port
system
Each storage system
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
295
P2X0-1030-09ENZ0