Adjusting The Brightness; Using The Ae Function - Sony MCC-3000MT Instructions For Use Manual

Adjusting the Brightness

This unit has an AE function that automatically
adjusts brightness through a combination of
adjustments to the total gain of the video amp and
shutter speed settings. You can also adjust the
brightness by using the BRIGHTNESS knob,
which also adjusts brightness through a
combination of total gain and shutter speed
settings. If you need to make manual adjustments
for special shooting conditions, you can set the
total gain and the shutter speed separately in the
Picture Profile menu.
Note
To prevent unintentional operation, adjustments
may not be registered if a knob is turned too
quickly. Turn the knob slowly.

Using the AE function

To turn the AE function on, press the AE button,
lighting it. The camera controls brightness by
switching automatically, according to shooting
conditions, between AGC (auto gain control)
mode and auto shutter mode.
Use "AE" (see page 35) in the Picture Profile
menu to set the adjustment level (AE level), the
adjustment mode, and the upper and lower limits
for AE function setting values.
To specify how light is measured before adjusting
the brightness, you can select from among five
light measurement areas (see page 29).
Note
The AE function (AE level) can be adjusted for
camera A, camera B, or both, but it cannot be
turned on/off separately for each camera.
Example:
Camera A: AE function On; Camera B: AE
function Off
AREA SEL button
AE button
BRIGHTNESS
knob
Setting the AE level
The AE level sets the automatic brightness
adjustment level, by specifying how much
brighter or darker it is than the standard level.
You can set the AE level with "AE" >"Level"
(see page 35) in the Picture Profile menu.
When the AE function is on, you can also rotate
the BRIGHTNESS knob to set the AE level.
Rotate it clockwise to increase the AE level
(make it brighter than the standard level) and
rotate it counterclockwise to decrease the AE
level (make it darker than the standard level). To
reset the AE level to the factory-default value,
you can hold down the BRIGHTNESS knob for
one or more seconds.
Selecting the light measurement area
Press the AREA SEL (light measurement area
selection) button.
The currently selected light measurement area
appears on the DISPLAY screen for three
seconds. The following figure is a conceptual
diagram of the light measurement areas that can
be selected.
MULTI: Whole screen
Adjusting the Brightness 29