Rack Mounting; Wru-806 Channel Setting - Sony SRP-X500P Operating Instructions Manual

Note
When removing the blank panels to the SRP-X500P, be
sure to start with the small panel.

Rack mounting

About the rack
Use an EIA-standard 19-inch rack with a depth of 450 mm
3
(17 / inches) or more.
4
Use four screws of the same diameter as the rack screw
holes and with an effective length of 12 mm (
more to mount the SRP-X500P into the rack.
Screws (+B M5 X
1
12 ( / inches))
2
SRP-X500P
Note
When mounting the SRP-X500P into a rack, be sure it is
done by 2 people or more.

WRU-806 channel setting

Take the following precautions to prevent interference and
noise.
• If there is a TV broadcasting station nearby, to avoid
possible interference from its broadcasting, do not use
that station's channel.
• When simultaneously using two or more tuners, always
set the tuners to different channels within the same group
(other than group 00).
16
Installation
1
/ inches) or
2
Rack
Screws (+B M5 X
1
12 ( / inches))
2
GP button
RF indicator
CH button
1
Turn on the SRP-X500P.
A message such as "CE62," "U66," and "AU66"
appears in the display window of the tuner unit, and
then channel indication appears.
2
Press and hold down the GP button, and press the + or
– button to select a group.
Each time you press the + or – button, the GP
indication changes as shown in the following figure.
To change the indication continuously, press and hold
down the + or – button.
GP CH
Display example of WRU-806B (CE62 model)
GP CH
Display example of WRU-806B (U66 model)
GP CH
Display example of WRU-806A (AU66 model)
+ button
– button
GP CH
GP CH
GP CH