Key To Symbols; Symbols On The Machine - Husqvarna DXR300 Operator's Manual

Symbols on the machine

WARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or fatal
injury to the operator or others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Noise emission to the environment
according to the European Community's
Directive. The machine's emission is
specified in the Technical data chapter and
on the label.
Always wear:
• Tight-fitting, heavy-duty and comfortable
clothing that permits full freedom of
movement.
• Sturdy, non-slip boots or shoes.
• Protective gloves.
• Protective helmet.
• Hearing protection.
• Protective goggles or a visor.
• A breathing mask, gas mask or fresh air helmet must be
used when working in environments where the air can be
harmful to health.
WARNING! Live parts.
WARNING! Ensure that no material can fall
down and cause damage when you are
using the machine.
WARNING! Watch out for demolition material
becoming loose when cutting. Use personal
safety equipment and keep your distance.
WARNING! Always position yourself above
the machine when driving on a slope. There
is a risk of the machine tipping.
WARNING! Exercise particular caution when
working close to edges. Ensure that the
machine is stable and does not move closer
to the edge while the work is in progress.
Ensure that the underlying surface has
satisfactory bearing capacity.
2 –
English

KEY TO SYMBOLS

Inspections and/or maintenance must
be carried out with the motor switched
off and the power cord disconnected.
Always connect the machine through
an ground fault circuit interrupter with
personal protection, i.e. an ground
fault circuit interrupter that trips at an ground fault of 30 mA.
Ensure that the power cable cannot
be run over. Take particular care
when moving or when the outriggers
are being retracted or extended. Risk
of electric shock.
The lifting equipment must be attached at all
the machine's lifting points.
Keep your distance! Nobody is permitted to
be within the machine's risk area when work
is underway. The machine's risk area can
vary during the course of the work.
The machine can overturn during work.
During operation the machine must be
positioned as level as possible and the
outriggers must be fully extended.
This product is in accordance with applicable
EC directives.
Environmental marking. Symbols on the
product or its packaging indicate that this
product cannot be handled as domestic
waste.
By ensuring that this product is taken care of
correctly, you can help to counteract the
potential negative impact on the environment
and people that can otherwise result through
the incorrect waste management of this product.
For more detailed information about recycling this product,
contact your municipality, your domestic waste service or the
shop from where you purchased the product.