Sony SRG-300H Operating Instructions Manual page 9

Use the supplied VISCA RS-422
connector plug.
H SYSTEM SELECT switch
Used for selecting the video format of
the signal to be output from the HDMI
video connector.
For details, see "Setting of the SYSTEM
SELECT switch" (page 10).
I HDMI video connector
Supplies the images as a HDMI video
signal or DVI video signal.
J IR SELECT switch
Select the camera number when you
operate multiple cameras with the same
infrared remote commander.
K VISCA IN connector
Connect to a computer via an RS-232
interface. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
L VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
M LAN connector (RJ-45 8-pin)
Connect to a switching HUB that is
compatible with 10BASE-T/100BASE-
TX using a LAN cable (category 5 or
higher, shielded twisted pair).
When a link is established, the green
indicator lights, and it flashes during
communication. While connected with
100BASE-TX, the yellow indicator also
lights.
CAUTION
For safety, do not connect the connector
for peripheral device wiring that might
have excessive voltage to this port.
Follow the instructions for this port.
N DC 12 V connector
Connect the supplied AC power adaptor.
O Reset switch
The reset switch is available only when
LAN is set. If you press this switch with
a pointed tip for about five seconds, the
camera will reboot and the IP settings
will return to the factory default.
Factory settings for IP
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Name: CAM1
Bottom
P BOTTOM switches
Used for LAN and VISCA CONTROL
switching, RS-232 and RS-422
switching, 9,600 bps and 38,400 bps
baud rate selection and IR signal output
setting.
For details, refer to the setting of the
BOTTOM switches (page 10).
Q Tripod screw hole
R Ceiling bracket mounting screw
holes
Location and Functions of Parts and Controls
9