Lan Connection - Sony SRG-300H Operating Instructions Manual

To connect the IP Remote
Controller using the VISCA RS-422
connectors
You can use the VISCA RS-422 connectors
to connect the RM-IP10 IP remote controller
to the camera instead of the VISCA RS-232
connectors. Use of the VISCA RS-422
connectors allows the connection up to
1,200 m (3,937 feet) away.
Prepare the connecting cable using the RS-
422 connector plugs that come with the
camera and the IP remote controller.
For making the cable, refer to "Using the
VISCA RS-422 connector pin assignments"
on pages 47, 48.
SRG-300H
VISCA
RS-422
MODE LAN RS-232C
VIS CA
1
RM-IP10 IP Remote
Controller
Notes
• When using the VISCA RS-422
connectors, check that the BOTTOM
switch on the bottom of the camera
(page 10) and the BOTTOM switch on the
bottom of the IP remote controller are set
to RS-422.
to the AC
power adaptor
(supplied)
VISCA
RS-422 cable
VISCA RS-422
!
RS-422 TAL LY/CONTACT
9 1 9
DC 12V
to the AC power
adaptor
(supplied with
the RM-IP10)
• When the connections using the VISCA
RS-422 connectors are made, the VISCA
RS-232 connection is not available.

LAN connection

SRG-300H
MODE LAN
RM-IP10 IP Remote
Controller
Notes
• In case of LAN connection, make sure that
the BOTTOM switch of the camera is set
for LAN connection (page 10).
• Use a LAN cable that is compatible with
10BASE-T/100BASE-TX (category 5 or
higher, shielded twisted pair) for this
connection.
• Use the crossover cable if you want to
connect directly to the LAN connector of
one camera and one IP remote controller
without using a switching hub.
to the AC
power adaptor
(supplied)
LAN cable
(not supplied)
!
RS-232C RS-422 TAL LY/CONTACT
VIS CA
1 9 1 9
DC 12V
to the AC
power adaptor
(supplied with
the RM-IP10)
35
Connections