Port Monitor Commands
monitor session destination interface
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To start a destination interface (monitoring) of a port monitor session (mirroring),
use the monitor session destination interface Global Configuration mode
command.
To stop a destination interface of a port monitoring session, use the no form of this
command.
Syntax
session-number
monitor session
packet]
session-number
no monitor session
Parameters
session-number
•
interface-id
•
—The destination interface ID. The interface must be an
Ethernet interface.
•
allow-ingress-packet—(Optional) Enables ingress traffic forwarding for the
destination interface.
Default Configuration
N/A
Command Mode
Global Configuration mode
User Guidelines
This command specifies the destination port for a monitor session. The following
restrictions apply to the ports that are configured to be monitored ports:
destination interface
destination interface
—The identifier for a port monitor session. (Range: 1 to 4)
27
interface-id
[allow-ingress-
interface-id
372