GE PKD915 Owner's Manual page 16

INSTALLING CABINET SUPPORT
23 /
1
IMPORTANT: When installed below a single or
double oven, check to be sure that any oven
supports above the cutout do not obstruct the
231/2" required depth of the warming drawer
cutout.
• A 2" minimum clearance between oven and
warming drawer cutouts are required. Additional
clearance may be required if 2 x 4 blocks are used
to support runners or solid floor of the oven above.
• The warming drawer may be supported by either
a solid bottom, 2 x 4 or 2 x 2 runners.
INSTALLING ANTI-TIP BRACE
WARNING:
•
The anti-tip brace must be installed to prevent the
drawer from tipping forward when opened and
loaded.
Failure to do so could result in personal injury.
16
Installation Instructions
2" x 4" or equivalent runners
"
2
22"
27"
ANTI-TIP PRECAUTIONS:
2" x 4" or equivalent
runners
23 / "
1
2
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
There is no way to level the drawer once it has
been installed. Be sure supports are level.
• The entire weight of the drawer is supported by
the runners or solid floor and must be capable of
supporting 150 lbs.
9"
2x4 or 2x2 runners
or solid bottom
25"
30"
Install 2x4 or 2x2 anti-tip
brace against rear cabinet
wall 9" from floor to
bottom of brace
49-80507-5