Table of Contents
Advertisement
EP SERVER RESTORE
Restore Database
EP SERVER RESTORE
Recovery USB Flash Drive
16-8
26. Verify that the OS boot Watchdog Timer is Disabled. If it is disabled
go to
Step
28. If it is Enabled, Highlight Disabled then, press the
Enter key.
27. Highlight Yes then, press the Enter
28. Press the F10 key.
29. The system will restart.
The system has been returned to its as-shipped condition. Remember
that the IP addresses, User Names and Passwords are reset to their
default values.
If a backup file is available use the following outline.
1. Refer to
Chapter –System Installation
procedures required to set the server name and IP addresses.
2. If this is a stand-alone server or Primary node go to
Member node go to
3. After the new system setup steps. Change the server to Member
status.
4. Access the restored server from the Primary server Enterprise
Manager.
5. Apply all licenses.
6. Restore the database. Refer to
the
"MANUAL RESTORE" on page Chapter 7 –-6
7. Synchronize the database.
The IPedge EP server uses a USB drive for the software recovery
process.
The follow procedure covers the creation of a Recovery USB flash drive.
The USB flash drive:
•
Must have a minimum capacity of 4 GB
•
Format must be FAT32
•
Single partition
•
This drive must be used only for IPedge EP system software
reocovery.
Important!
The following procedure will format the USB flash drive.
Any data on the drive will be lost.
1. Before starting this procedure perform a virus check on the USB flash
drive using a PC.
2. Insert USB flash drive into a connector on the IPedge EP server.
3. Login the Enterprise Manager. Select Application > Webmin.
4. In Webmin select IPedge > Make MBR in USB. in webmin to create
MBR in USB flash drive.
in this manual for the
Step
3.
Chapter –IPedge System Backup
Installation Manual
Restore Database
Step
5. If this is a
in
section.
August, 2011
Hide quick links:
Advertisement
Table of Contents
