D-Link DES-1228/ME Reference Manual page 397

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
80A4A368 : 00000008 80255BE0 0000001A 00000008
80A4A378 : 802CFB4C 876ECD40 80247308 802472D8
80A4A388 : 802133FC 00000001 00000000 80A4A408
80A4A398 : 00000000 00000000 00000000 87482BB0
80A4A3A8 : 00000000 00000001 00000001 00000008
80A4A3B8 : 80A4A3E0 00000001 00000000 80247594
80A4A3C8 : 80A4A518 806D3164 00000000 000017A0
80A4A3D8 : 874C6F10 80A4A40C 00000000 00000000
80A4A3E8 : 00000000 87482BB0 00000000 00000008
80A4A3F8 : 876DC990 00000008 876DC990 876ECD40
-------------------- TASK STACKTRACE --------------------
->0x8018b8c0
->0x802134b0
->0x8023e7b0
->0x8023f030
->0x80247c18
->0x8024758c
->0x802472d0
->0x8092ccb8
->0x80189b40
->0x801bd988
Success.
DES-1228/ME:5#
debug config error_reboot
Purpose This command is used to set if the switch needs to be rebooted when
a fatal error occurs. When the error occurs, the watchdog timer will be
disabled by the system first, and then all debug information will be
saved in NVRAM. If the error_reboot is enabled, the watchdog shall
be enabled after all information is stored into NVRAM.
Syntax debug config error_reboot [enable | disable]
393