Debug Software Commands - D-Link DES-1228/ME Reference Manual

The Debug Software commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
debug error_log
debug config
error_reboot
debug show error_reboot
state
debug error_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To dump the error log:
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
[dump | clear | upload_toTFTP [<ipaddr> ] <path_filename
64>]
[enable | disable]
Use this command to dump, clear or upload the software error log to a
TFTP server.
debug error_log [dump | clear | upload_toTFTP [<ipaddr> ]
<path_filename 64>]
Dump, clear or upload the debug log to a TFTP server. The "error log"
here refers to the software error log stored in NVRAM.
dump − Display the debug message of the debug log.
clear − Clear the debug log.
upload_toTFTP − Upload the debug log to a TFTP server specified by
IP address.
<ipaddr> − Specifies the IPv4 address of the TFTP server.
<path_filename 64> − The pathname specifies the DOS pathname on
the TFTP server. It can be a relative pathname or an absolute
pathname.
Only Administrator-level users can issue this command.
D S
EBUG OFTWARE
384
51
C
OMMANDS