Changing Priorities Status While Scan Is On; Restoring Priorities In A Scan List; Hang Up (Hub) - Motorola ASTRO APX O2 Control Head Mobile Radio User Manual



Changing Priorities Status While Scan is On

While the radio is scanning, the dynamic priority change feature
allows you to temporarily change any channel in a scan list
(except for the Priority-One channel) to the Priority-Two
channel.
This change remains in effect until scan is turned off. Scan then
reverts to the preprogrammed (original) setting.
Procedure:
1 Press the Menu Select button directly below Dynp to
change the priority of a non-priority channel in the scan list
to Priority-Two.
H
2 Press momentarily to exit the scan list and resume
scanning.


Restoring Priorities in a Scan List

Procedure:
To restore the original channel priorities in a scan list, do one of
the following:
• Turn scan off, then on.
OR
• Change channels.
OR
• Turn off the radio, and then turn it back on.


Hang Up (HUB)

To temporarily suspend Scan Mode operation, remove the
control head from the Hang Up Box (HUB). You are allowed to
use the control head while scan is suspended. However, Priority
Member scanning is not suspended. This feature applies to all
Scan Lists and Scan Types. Scan is resumed once the control
head is returned to the holding clip and the preprogrammed
hang time has elapsed.
Note: Priority Scan List members are continuously scanned
only when the Scan List, Designated Tx Member field
is set to "Talkback" in the radio programming.
Otherwise, all scan mode operation is suspended.
57
English