Motorola ASTRO APX O2 Control Head Mobile Radio User Manual page 3

®
ASTRO APX™
O2 Control Head Mobile Radio
Quick Reference Card
RF Energy Exposure and Product Safety Guide for
Mobile Two-way Radios
Before using this product, read the operating
!
instructions for safe usage contained in the Product
a u t i o n
Safety and RF Exposure booklet enclosed with your
radio.
ATTENTION!
This radio is restricted to occupational use only to satisfy FCC RF
energy exposure requirements. Before using this product, read
the guide enclosed with your radio which contains important
operating instructions for safe usage and RF energy awareness
and control for compliance with applicable standards and
regulations.
Radio Controls
LED Indicators
Up & Down Emergency
Power Button
Buttons* Button*
Multi-function Knob
(MFK)*
Home Button
Dimmer Button
Menu Select Buttons*
Accessory Port (Microphone)
*These controls/buttons are programmable.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered trademarks of Motorola
Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners.
© 2012 by Motorola Solutions, Inc. All Rights Reserved. 10/12
1303 East Algonquin Road, Schaumburg, Illinois 60196, U.S.A.
Radio On/Off
Press the Power button to turn the radio on or off.
Adjusting Volume
If volume is set as the primary mode,
1
Turn the MFK clockwise to increase volume or
counterclockwise to decrease the volume.
If volume is not set as the primary mode, press the MFK
once and repeat step 1.
Selecting a Zone
If zone is set as the primary mode,
1
Turn the MFK until the display shows the desired
zone and press the PTT button to begin transmitting
on the displayed zone.
If zone is not set as the primary mode, press the MFK
once and repeat step 1.
OR
> <
2
(on the keypad mic.) to scroll to Zone.
or
3
Press the Menu Select button directly below Zone.
D U
4
Rotate the MFK or or to the desired zone.
5
Press the Menu Select button directly below Sel or
the 3 button (on the keypad mic.) to confirm the
selected zone number.
6
Press the PTT button to begin transmitting on the
displayed zone.
Selecting a Channel
If channel is set as the primary mode,
1
Turn the MFK until the display shows the desired
channel and press the PTT button to begin
transmitting on the displayed channel.
If channel is not set as the primary mode, press the MFK
once and repeat step 1.
OR
> <
2
(on the keypad mic.) to scroll to Chan.
or
3
Press the Menu Select button directly below Chan.
D U
4
Rotate the MFK or press or to the desired
channel.
5
Press the Menu Select button directly below Sel or
the 3 button (on the keypad mic.) to confirm the
channel.
6
Press the PTT button to transmit on the displayed
channel.
Receiving and Transmitting
1
Take the microphone off the hook.
2
Select zone/channel.
3
Listen for a transmission.
OR
> <
(on the keypad mic.) to Mon then press the
or
Menu Select button directly below Mon and listen for
activity.
4
Adjust volume, if necessary.
5
Press the PTT button to transmit; release to receive.
Sending an Emergency Alarm
1
Press the Emergency button. A tone sounds and the
display alternates Emergency and the home display.
2
A dispatcher acknowledgment Ack received display
follows.
AND, Trunking Only:
A high-pitched tone indicates that the alarm has been
received by the trunked system's central controller.
*PMLN6193B*
PMLN6193B
English