Brother DCP-8110DN Service Manual page 224

(4) Remove the taptite flat B M3x10 screw from the inlet.
(5) Remove the screw pan M4x8, washer spring 2-4, washer 5, and remove the earth
harness from the machine.
(6) Remove the inlet and the power switch from the machine.
Note:
• When removing the power switch, use a flathead screwdriver or similar tool to lift
the edge of the power switch to remove it.
Housing
Earth harness
Power switch
Screw pan M4x8
Assembling Note:
• When attaching the power switch, align the marking on the power switch with the
engraved marking on the machine.
• Attach the inlet as shown in the illustration above.
• Insert the inlet harness into the housing of the machine.
Inlet
Washer 5
Taptite flat B M3x10
Washer spring 2-4
Fig. 3-106
3-78
Power switch
Marking
1
2
Engraved
marking
Confidential