Article 820 regarding installation of CATV systems. 7. Servicing - Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Bosch Security Systems | 15 May 2003...
The user may find the following booklet, prepared by the Federal Communications Commission, helpful: How to Identify and Resolve Radio-TV Interference Problems. This booklet is available from the U.S. Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4. Bosch Security Systems | 15 May 2003...
IEC Publication 245. Cordons d’alimentation 220-240 V, 50 Hz Les cordons d’alimentation 220-240 V, 50 Hz, d’entrée ou de sortie, doivent être conformes à la dernière version de la publication IEC 227 ou IEC 245. Bosch Security Systems | 15 May 2003...
Los cables de alimentación de 220-240 V, 50 Hz, tanto en la entrada den neuesten Versionen der IEC Publikation 227 oder IEC como en la salida, deben cumplir las versiones más modernas de las Publikation 245 entsprechen. publicaciones IEC 227 o 245. Bosch Security Systems | 15 May 2003...
Page 6
I cavi di alimentazione a 220-240 V, 50 Hz devono essere conformi meest recente uitgave van IEC publicatie 227 of IEC publicatie 245. (ingresso e uscita) alle versioni più recenti della pubblicazione IEC 227 o IEC 245. Bosch Security Systems | 15 May 2003...
Page 7
Kable zasilające 220-240 V, 50 Hz, oraz wejścia i wyjścia muszą być zgodne z recentes da publicação CEI 227 ou publicação CEI 245. ostatnimi wersjami Publikacji 227 lub 245 IEC. Bosch Security Systems | 15 May 2003...
If the item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify your Bosch Security Figure 1: Dimensional Outline (Camera Module Systems, Inc. Sales Representative or Customer Service Assembled in Backbox) Representative.
Slide the base plate to desired position on top of the tile. Photo 5: Safety Cable Fitment 5. Cut a hole in the tile using the bracket as a template (PHOTO 6). Photo 3: Bracket Clip Fitting Photo 6: Cutting the Tile Bosch Security Systems | 15 May 2003...
2. Push the optional ring over the mounting box clips (PHOTO 8). Photo 10: Installed Backbox 3. Tighten the two (2) flexible clamp screws. DO NOT OVER TIGHTEN (PHOTO 11). Photo 8: Mounting Ring Securing Photo 11 Securing Backbox Bosch Security Systems | 15 May 2003...
3. When power is applied, a red LED will light. Signal Cable, Connecting RS-232 Signal Cable, and Connecting Video Cable (PHOTO 14 through Wiring Chart PHOTO 17). 24 VAC, 40 VA Max Wire Size Maximum Distance Bosch Security Systems | 15 May 2003...
Connect the GND of each of the cables in a similar manner. A 110 OHM RESISTOR MUST BE CONNECTED BETWEEN THE BIPHASE (+) AND (-) TERMINALS ON THE LAST CAMERA. Photo 17: Ferrite Placement Bosch Security Systems | 15 May 2003...
CAUTION: Do not remove camera from pan/tilt. Remove the entire receiver/driver, pan/tilt, and camera assembly from the AutoDome system to prevent damage to the flexible cable and connector. Bosch Security Systems | 15 May 2003...
Page 15
EN | 15 Suspended Ceiling Mount Backbox Modules | Instruction Manual | Notes Bosch Security Systems | 15 May 2003...