Siemens SISTORE AX Installation Instructions Manual page 30

Installation and replacement of hard disk drives
NOTE
In order for the additional hard disk unit to be addressed by the SISTORE AX application software, it must be
identified as an additional data disk in the „System" configuration menu and be formatted
30
Siemens Building Technologies
Fire Safety & Security Products
4. Fasten the cooling frame and the
additional hard disk unit within the
device using the four screws supplied
(as marked in the picture).
5. Close cable tie.
6. Fasten the housing cover using the
previously removed screws.
7. Start up the device. Please refer to the
instruction manual for SISTORE AX.
The new hard disk capacity will be
displayed in the OSD menu "Storage
information". Before you can start
recording data, the use needs to be
defined and the hard disk to be formatted
(see SISTORE AX8/AX16 500/200 User
Manual). In case the device is operated in
the Recycle mode, first the Stop mode
needs to be configured before switched
back to the recycle mode.
03.2009