Replacing Door Hinge Receptacle - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

The door hinges engage steel pins in the hinge receptacles which are mounted on the back side of
the front chassis. The following instructions will explain the steps necessary for the various styles of
ranges that you may encounter.
Begin by removing the oven door and warmer drawer or storage drawer as described in previous sec-
tions of this manual.
Remove warmer drawer side shields.
(Models With Warmer Drawer)
1. From the rear of the range remove the screws that
secure the shields to the main back panel (Fig1).
2. From the front of range remove the screws
that secure the drawer glide rail (Fig 2).
The drawer glide rail and drawer shield can be removed
together by pulling straight forward.
Remove hinge receptacle
1. Remove the two self tapping
screws that secure the receptacle to
the oven chassis frame (Fig 3).
The receptacle may fall into the body-
side leg channel but it can be easily
retrieved.
U
SE CAUTION TO AVOID BEING CUT
BY ANY EXPOSED SHARP EDGES
Install new receptacle
1. The new receptacle will have a
black colored roller pin. Make sure to
install the receptacle with the narrow
end of the slot at the bottom (Fig. 4).
TIP: To ease installation of new receptacle,
install and remove the self tapping screws into
the screw holes in the new receptacle . This
will pre-cut threads into the hinge and allow for
easier starting of the screws once the hinge is
in position.
2. Carefully position the receptacle behind the front
chassis and install the mounting screws (Fig. 5)
3. Reinstall warmer drawer side shields & glide rails,
warmer drawer and oven door.

Replacing Door Hinge Receptacle

WARNING
Mounting
Screws
.
Fig.3
New
receptacle
with black
colored pin
Fig. 4
Page 35
Side Shield Screws
Rear of Range
Fig. 1
Guide Rail Screw
DRAWER GUIDE RAIL
DRAWER SIDE SHIELD
Fig. 2
Fig. 5
P/N 316439221